The forward bulkhead is nice and secure. I had applied pressure in a few points overnight in an attempt to make the front of the canopy as true as possible. I’m very happy with the results. There are a few areas that will need further adjustment later on, but for now I can forge ahead.

I have an Independence Day cookout to attend this afternoon, so I didn’t have much time. I wanted to get the rear bulkhead fastened with flox, so that I could move on to the center bulkhead tomorrow when I have a full day to work. Just like the forward bulkead, it should be 1/4 inch away from the fuselage bulkhead. I used popsicle sticks as my buffer. 4 sticks is exactly 1/4 inch. I secured them with packing tape so that they wouldn’t adhere to any overflowing flox. Given the rear tilt of this bulkhead, I full suspect it will leak in that direction.

I clamped it in position, applied flox, and closed the canopy skirt. I secured the canopy skirt with tape.

Here is the rear bulkhead after applying the flox.

I grabbed some small wooden coffee stirrers at the hotel during my last trip. The small size was perfect for applying flox in some of the gaps and creating a small fillet. I only have 3, so I’ll have to check on Amazon for a cheap box.

I ordered some torx screws to replace the philips screws in the aircraft. Here there are after organizing.

With temperatures outside in the 90s, the hangar is probably well over 110 in the day. The working time for the fast hardener is about 15 seconds, and given I have a substantial amount of fiberglass work ahead of me, I decided to save myself the excruciating effort of running all over the place in a race against time. I bought the slow hardener. And in this heat, its not really “slow”.

I also bought the hysol adhesive that will be used to adhere the canopy to the canopy skirt.

First project for today was to cut and drill the hinge cover. I placed the hinge in position, got a good measure of its correct positioning, and then removed the hinge for drilling. I held the two parts together and used the hinge to match drill.

I’m very happy with the results. Its a near perfect seal when installed.

My final project for the evening was to prepare and fasten the forward canopy skirt bulkhead. Show Planes provides honeycomb inserts for this, and they are bonded using a mixture of flox. It took quite some time to get things fitting just perfectly. Patience and incremental adjustment is key for this work. When you move one part, you invariably move another.

Here you can see the flox mixture in place with the canopy skirt closed and clamped into position.