Rudder 1 (1.0 hr)


After finishing all the priming prep for the vertical stabilizer its time for the rudder.  I found all the appropriate parts for the rudder and laid them out.  Then I set about removing the blue protective coating with my soldering iron.  My wife helped me remove some of the protective coating but we had a bit of a whoops at the end, putting a very small crinkle in the rudder skin.  I was a little upset, but its barely noticeable.  20130413-171519.jpg

20130413-171526.jpg


About Peter

plbarrett.com | Certified Flight Instructor (Single & Multi-Engine, Instrument, and Advanced Ground) | Commercial Helicopter

Leave a comment