This post covers a couple different shop sessions, but it easiest to combine all here. First I installed the canopy on the rails. Next I started installing all of the latch mechanisms. I’m pretty sure I covered that on here way back when I initially did all the work. I did have to make some slight changes to the locking mechanism lengths.

I also created strike plates out of plastic at each end of the locking mechanism. I completed the taxi latch position. I used some tape and a little pressure to mark the appropriate drilling location.

I’m really happy with the result. The lock is still pretty stiff, but I suspect it will loosen with time. Also I over adjusted the gas strut, and it has less power than I would like. I’ll probably replace it at some point. (Edit: I replaced with one provided by my buddy Keith. I kept it much more stiff and I’m very happy with it.)