FWF Wire Routing and Termination
Multiple shop sessions routing, organizing, and terminating wire FWF and elsewhere.
Category
Electrical
Posts filed under Electrical.
Build 252 hrs
Featured Posts
33 total posts
GNC Setup
GNC was not communicating properly with the G3X system. Troubleshooting and solution.
Capacitive fuel sender, nav/strobes and other aft wiring
Fuel sender wiring. Nav/Strobe controller wiring. Aft wiring.
Chronological Archive
- Sportair Electrical Systems & Avionics No hours recorded
- Landing Lights Build 5 hrs
- Electrical System Planning Build 12 hrs
- Avionics 1 Build 15 hrs
- Antennas 1 Build 3 hrs
- Nav & Strobe Lights Build 6 hrs
- Avionics layout, test panel fab, and bus layout planning Build 15 hrs
- ELT Installation Build 3 hrs
- Harness Building on the Bench Build 20 hrs
- Elevator Trim Installation and Wiring Build 2 hrs
- Removal of stall warning, switch panel, fuselage wiring Build 6 hrs
- Starter solenoid wiring, pitot wiring, fuel vents. Build 3 hrs
- Capacitive fuel sender, nav/strobes and other aft wiring Build 7 hrs
- Panel cutting & fitment plus lots of wiring Build 8 hrs
- Cabin Lighting Testing and Installation Build 4 hrs
- Panel Switches Build 3 hrs
- GMU11 Install Build 3 hrs
- General Wiring Work Build 8 hrs
- Primary Power Panel Wiring Build 4 hrs
- Pre-power wiring Build 8 hrs
- Initial Panel Power Up! Build 3 hrs
- GNC Setup Build 6 hrs
- GEA 24 Wiring Build 10 hrs
- Headset wiring Build 2 hrs
- Radio Transmit Troubleshooting Build 4 hrs
- GEA24 Wiring 2 Build 8 hrs
- FWF Wire Routing and Termination Build 28 hrs
- Magneto Ignition Harness and Prop Safety Wire Build 4 hrs
- FWF Work. Ignition wires and oil temp sensor. Build 8 hrs
- CAN BUS ERROR!!! OH GAWD! Build 15 hrs
- Instrument Panel Finalization Build 20 hrs
- Misc wrap up work Build 5 hrs
- Magnetometer and AHARS Calibration Build 4 hrs