GNC Setup
GNC was not communicating properly with the G3X system. Troubleshooting and solution.
Category
Avionics
Avionics installation, configuration, wiring, and panel decisions.
Build 128 hrs
Featured Posts
14 total posts
Harness Building on the Bench
Building the harness on my home work bench.
Avionics layout, test panel fab, and bus layout planning
Building an instrument panel mockup, playing with avionics layout behind the panel, and locating the various buses.
Chronological Archive
- Avionics 1 Build 15 hrs
- Avionics layout, test panel fab, and bus layout planning Build 15 hrs
- Harness Building on the Bench Build 20 hrs
- Panel Switches Build 3 hrs
- GMU11 Install Build 3 hrs
- Initial Panel Power Up! Build 3 hrs
- GNC Setup Build 6 hrs
- GEA 24 Wiring Build 10 hrs
- Headset wiring Build 2 hrs
- Radio Transmit Troubleshooting Build 4 hrs
- GEA24 Wiring 2 Build 8 hrs
- CAN BUS ERROR!!! OH GAWD! Build 15 hrs
- Instrument Panel Finalization Build 20 hrs
- Magnetometer and AHARS Calibration Build 4 hrs